Document

Notice Pursuant to the National Cooperative Research and Production Act of 1993Department of Commerce Advanced Technology Program Cooperative Agreement No. 70NANB5H1144 ``Flow Control Machining''

[Federal Register Volume 61, Number 70 (Wednesday, April 10, 1996)] [Notices] [Pages 15969-15970] From the Federal Register Online via the Government Publishing Office [ www.gpo...

[Federal Register Volume 61, Number 70 (Wednesday, April 10, 1996)]
[Notices]
[Pages 15969-15970]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 96-8866]



-----------------------------------------------------------------------


DEPARTMENT OF JUSTICE ANTITRUST DIVISION

Notice Pursuant to the National Cooperative Research and 
Production Act of 1993--Department of Commerce Advanced Technology 
Program Cooperative Agreement No. 70NANB5H1144 ``Flow Control 
Machining''

    Notice is hereby given that, on February 5, 1996, pursuant to 
Section 6(a) of the National Cooperative Research and Production Act of 
1993, 15 U.S.C. Sec. 4301 et seq. (``the Act''), Extrude Hone 
Corporation, for itself and for the participants in the Department of 
Commerce Advanced Technology Program Cooperative Agreement No. 
70NANBSH1144 ``Flow Control Machining'' (the ``Cooperative 
Agreement''), has filed written notifications simultaneously with the 
Attorney General and the Federal Trade Commission disclosing (1) the 
identities of the parties and (2) the nature and objectives of the 
Cooperative Agreement. The notifications were filed for the purpose of 
invoking the Act's

[[Page 15970]]
provisions limiting the recovery of antitrust plaintiffs to actual 
damages under specified circumstances. Pursuant to Section 6(b) of the 
Act, the identities of the parties and its general areas of planned 
activity are Extrude Hone Corporation, Irwin, PA; Ford Motor Company, 
Dearborn, MI; General Motors Corporation, Pontiac, MI; University of 
Pittsburgh, Pittsburgh, PA; and University of Nebraska, Lincoln, NE. 
The general areas of planned activity for the parties to the 
Cooperative Agreement are to develop and demonstrate techniques for the 
flow control machining of aspiration passages and combustion chambers 
for automotive production.
Constance K. Robinson,
Director of Operations, Antitrust Division.
[FR Doc. 96-8866 4-9-96; 8:45 am]
BILLING CODE 4410-01-M

Legal Citation

Federal Register Citation

Use this for formal legal and research references to the published document.

61 FR 15969

Web Citation

Suggested Web Citation

Use this when citing the archival web version of the document.

“Notice Pursuant to the National Cooperative Research and Production Act of 1993Department of Commerce Advanced Technology Program Cooperative Agreement No. 70NANB5H1144 ``Flow Control Machining'',” thefederalregister.org (April 10, 1996), https://thefederalregister.org/documents/96-8866/notice-pursuant-to-the-national-cooperative-research-and-production-act-of-1993department-of-commerce-advanced-technolog.