Airworthiness Directives; McDonnell Douglas Model MD-11 Series Airplanes

Comments Invited

Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this notice may be changed in light of the comments received. Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filed in the Rules Docket. Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this notice must submit a self-addressed, stamped postcard on which the following statement is made: ``Comments to Docket Number 99-NM-170-AD.'' The postcard will be date stamped and returned to the commenter.

Availability of NPRMs

Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 99-NM-170-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.

Discussion

As part of its practice of re-examining all aspects of the service experience of a particular aircraft whenever an accident occurs, the FAA has become aware of loose terminal attachment hardware on the air driven generator (ADG) power monitor relay. This incident occurred on a Model MD-11 series airplane during a heavy maintenance check. A subsequent inspection found other airplanes with similar loose terminal attachment hardware with internally broken lugs, including one airplane with a broken wire. During a Boeing investigation of production airplanes, it was revealed that the wire assembly connected to the ADG was installed with no slack, which caused a stress condition on the terminal attachment points, and resultant loose terminals and loss of the charging capability of the ADG. This condition, coupled with a loss of all normal electrical power, if not corrected, could prevent continued safe flight and landing of the airplane. This incident is not considered to be related to an accident that occurred off the coast of Nova Scotia involving a McDonnell Douglas Model MD-11 series airplane. The cause of that accident is still under investigation.

Other Related Rulemaking

The FAA, in conjunction with Boeing and operators of Model MD-11 series airplanes, is continuing to review all aspects of the service history of those airplanes to identify potential unsafe conditions and to take appropriate corrective actions. This proposal is one of a series of proposed actions identified during that process. The process is continuing and the FAA may consider additional rulemaking actions as further results of the review become available.

Explanation of Relevant Service Information

The FAA has reviewed and approved McDonnell Douglas Service Bulletins MD11-24-128, dated September 17, 1998, and Revision 1, dated July 30, 1999, which describes procedures for replacement of the ADG wire assembly with a new, increased length wire assembly. Accomplishment of the action specified in the service bulletin is intended to adequately address the identified unsafe condition.

Explanation of Requirements of Proposed Rule

Since an unsafe condition has been identified that is likely to exist or

develop on other products of this same type design, the proposed AD would require accomplishment of the actions specified in the service bulletin described previously.

Cost Impact

There are approximately 180 airplanes of the affected design in the worldwide fleet. The FAA estimates that 60 airplanes of U.S. registry would be affected by this proposed AD, that it would take approximately 1 work hour per airplane to accomplish the proposed replacement, and that the average labor rate is $60 per work hour. Required parts would cost approximately $786 per airplane. Based on these figures, the cost impact of the proposed AD on U.S. operators is estimated to be $50,760, or $846 per airplane. The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted.

Regulatory Impact

The regulations proposed herein would not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this proposal would not have sufficient federalism implications to warrant the preparation of a Federalism Assessment. For the reasons discussed above, I certify that this proposed regulation (1) Is not a ``significant regulatory action'' under Executive Order 12866; (2) Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) If promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

McDonnell Douglas: Docket 99-NM-170-AD.

Applicability: Model MD-11 series airplanes, as listed in McDonnell Douglas Service Bulletin MD11-24-128, Revision 1, dated July 30, 1999; certificated in any category.

Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously. To prevent loss of the charging capability of the air driven generator (ADG), that when coupled with a loss of all normal electrical power, could prevent continued safe flight and landing of the airplane, accomplish the following:

Replacement

(a) Within 1 year after the effective date of this AD, replace the ADG wire assembly, part number (P/N) ACS9006-501, with a new, increased length wire assembly, P/N ACS9006-502, in accordance with McDonnell Douglas Service Bulletin MD-11-24-128, dated September 17, 1998, or Revision 1, dated July 30, 1999.

Alternative Methods of Compliance

(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Los Angeles ACO.

Note 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Los Angeles ACO.

Special Flight Permits

(c) Special flight permits may be issued in accordance with Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

Issued in Renton, Washington, on October 20, 1999. D.L. Riggin, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 99-27946 Filed 10-26-99; 8:45 am] BILLING CODE 4910-13-U