81 FR 28 - Airworthiness Directives; Dassault Aviation
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration Federal Register Volume 81, Issue 1 (January 4, 2016)
Federal Aviation Administration
Federal Register Volume 81, Issue 1 (January 4, 2016)
| Page Range | 28-30 | |
| FR Document | 2015-32891 |
[Federal Register Volume 81, Number 1 (Monday, January 4, 2016)] [Proposed Rules] [Pages 28-30] From the Federal Register Online [www.thefederalregister.org] [FR Doc No: 2015-32891] ----------------------------------------------------------------------- DEPARTMENT OF TRANSPORTATION Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2015-7532; Directorate Identifier 2015-NM-069-AD] RIN 2120-AA64 Airworthiness Directives; Dassault Aviation AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Notice of proposed rulemaking (NPRM). ----------------------------------------------------------------------- SUMMARY: We propose to adopt a new airworthiness directive (AD) for all Dassault Aviation Model FALCON 7X airplanes. This proposed AD was prompted by reports of multiple cases of ram air turbine (RAT) blade damage. [[Page 29]] This proposed AD would require deployment of the RAT, replacement of the RAT placard with a new RAT placard, and re-identification of the RAT. We are proposing this AD to prevent blade damage to the RAT which could prevent RAT deployment in flight during an emergency, possibly resulting in reduced control of the airplane. DATES: We must receive comments on this proposed AD by February 18, 2016. ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments. Fax: 202-493-2251. Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590. Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. For service information identified in this proposed AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, NJ 07606; telephone: 201-440-6700; Internet http://www.dassaultfalcon.com. You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. Examining the AD Docket You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015- 7532; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt. FOR FURTHER INFORMATION CONTACT: Tom Rodriquez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone: 425-227-1137; fax: 425-227-1149. SUPPLEMENTARY INFORMATION: Comments Invited We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2015-7532; Directorate Identifier 2015-NM-069-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments. We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD. Discussion The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2015-0076, dated May 6, 2015 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for all Dassault Aviation Model FALCON 7X airplanes. The MCAI states: A few cases of Ram Air Turbine (RAT) blade damage have been reported during maintenance operations. This kind of damage is caused by an incorrect locking of RAT rotor, due to improper positioning of blades at beginning of retraction, and locking check during retraction, which likely occurs during stowage of the RAT, after its deployment for maintenance purposes. This condition, if not corrected, could prevent RAT deployment in flight during an emergency, possibly resulting in reduced control of the aeroplane. To address this potential unsafe condition, Dassault Aviation issued Service Bulletin (SB) 7X-289, which provides instructions to smoothly deploy the RAT and install an improved placard to ensure proper RAT stowage/retraction after maintenance. For the reasons described above, this [EASA] AD requires replacement of the existing RAT placard with a new placard and RAT re-identification. This [EASA] AD also provides conditions for installation of a RAT on an aeroplane. You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015- 7532. Related Service Information Under 1 CFR Part 51 Dassault Aviation has issued Dassault Mandatory Service Bulletin 7X-289, dated January 21, 2015. The service information describes procedures for deployment of the RAT, replacement of the RAT placard with a new RAT placard, and re-identification of the RAT. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section of this NPRM. FAA's Determination and Requirements of This Proposed AD This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design. Costs of Compliance We estimate that this proposed AD affects 45 airplanes of U.S. registry. We also estimate that it would take about 4 work-hours per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Required parts would cost about $121 per product. Based on these figures, we estimate the cost of this proposed AD on U.S. operators to be $20,745, or $461 per product. According to the manufacturer, some of the costs of this proposed AD may be covered under warranty, thereby reducing the cost impact on affected individuals. We do not control warranty coverage for affected individuals. As a result, we have included all costs in our cost estimate. Authority for This Rulemaking Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority. We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in [[Page 30]] air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. Regulatory Findings We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. For the reasons discussed above, I certify this proposed regulation: 1. Is not a ``significant regulatory action'' under Executive Order 12866; 2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); 3. Will not affect intrastate aviation in Alaska; and 4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. List of Subjects in 14 CFR Part 39 Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. The Proposed Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): Dassault Aviation: Docket No. FAA-2015-7532; Directorate Identifier 2015-NM-069-AD. (a) Comments Due Date We must receive comments by February 18, 2016. (b) Affected ADs None. (c) Applicability This AD applies to Dassault Aviation Model FALCON 7X airplanes, certificated in any category, all serial numbers. (d) Subject Air Transport Association (ATA) of America Code 24, Electrical power. (e) Reason This AD was prompted by reports of multiple cases of ram air turbine (RAT) blade damage. We are issuing this AD to prevent blade damage to the RAT which could prevent RAT deployment in flight during an emergency, possibly resulting in reduced control of the airplane. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Placard Replacement Except as provided by paragraph (h) of this AD: Within 28 months or during the next accomplishment of the RAT functional test, whichever occurs first after the effective date of this AD, deploy the RAT, replace the RAT placard with a new RAT placard, and re- identify the RAT part number (P/N) 1705673A to a part number identified in paragraph (g)(1) or (g)(2) of this AD, in accordance with the Accomplishment Instructions of Dassault Mandatory Service Bulletin 7X-289, dated January 21, 2015. (1) Change P/N 1705673A to P/N 1705673B. (2) Change P/N 1705673A to a part number that is approved as a replacement for P/N 1705673A and approved as part of the type design by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA); or Dassault Aviation's EASA Design Organization Approval (DOA); after the issue date of Dassault Mandatory Service Bulletin 7X-289, dated January 21, 2015. (h) Exception to Paragraph (g) of This AD An airplane on which Dassault Aviation Modification M1428 has been embodied in production is not affected by the requirements of paragraph (g) of this AD, provided no RAT P/N 1705673A has been installed on that airplane since first flight. (i) Parts Installation Prohibition As of the effective date of this AD, no person may install a RAT, part number 1705673A, on any airplane. (j) Other FAA AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriquez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone: 425-227- 1137; fax: 425-227-1149. Information may be emailed to: [email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/ certificate holding district office. The AMOC approval letter must specifically reference this AD. (2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA); or Dassault Aviation's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. (k) Related Information (1) Refer to Mandatory Continuing Airworthiness Information (MCAI) EASA AD 2015-0076, dated May 6, 2015, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-7532. (2) For service information identified in this AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, NJ 07606; telephone: 201-440-6700; Internet http://www.dassaultfalcon.com. You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. Issued in Renton, Washington, on December 18, 2015. Jeffrey E. Duven, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 2015-32891 Filed 12-31-15; 8:45 am] BILLING CODE 4910-13-P
Document Created: 2015-12-31 23:05:09
Document Modified: 2015-12-31 23:05:09
| Category | Regulatory Information | |
| Collection | Federal Register | |
| sudoc Class | AE 2.7: GS 4.107: AE 2.106: | |
| Publisher | Office of the Federal Register, National Archives and Records Administration | |
| Section | Proposed Rules | |
| Action | Notice of proposed rulemaking (NPRM). | |
| Dates | We must receive comments on this proposed AD by February 18, 2016. | |
| Contact | Tom Rodriquez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone: 425-227-1137; fax: 425-227-1149. | |
| FR Citation | 81 FR 28 | |
| RIN Number | 2120-AA64 | |
| CFR Associated | Air Transportation; Aircraft; Aviation Safety; Incorporation by Reference and Safety |
2025 Federal Register | Disclaimer | Privacy Policy
USC | CFR | eCFR